Corel HMS Victory. How would I stow/display the oars? On board the boat? Lashed how? Etc.
Thanks guys.
You are viewing the archived version of the site.
Go to modelshipwrights.com for the current dynamic site!
Go to modelshipwrights.com for the current dynamic site!
General Ship Modeling
Discuss modeling techniques, experiences, and ship modeling in general.
Discuss modeling techniques, experiences, and ship modeling in general.
Hosted by Jim Starkweather
How to stow oars on a davit boat
guitarrachico
Washington, United States
Joined: January 30, 2017
KitMaker: 2 posts
Model Shipwrights: 1 posts
Joined: January 30, 2017
KitMaker: 2 posts
Model Shipwrights: 1 posts
Posted: Sunday, January 29, 2017 - 10:29 PM UTC
Posted: Tuesday, January 31, 2017 - 08:09 PM UTC
I display them just laying in the boat.
RedDuster
England - South East, United Kingdom
Joined: March 01, 2010
KitMaker: 7,078 posts
Model Shipwrights: 6,649 posts
Joined: March 01, 2010
KitMaker: 7,078 posts
Model Shipwrights: 6,649 posts
Posted: Wednesday, February 01, 2017 - 02:40 AM UTC
Hi Frank,
I would have them blades towards the bow of the boat, half on each side the of the boat. Lashings not 100% sure about that era, most likely lashed to the thwarts (seats) either round the oars, under the thwart, buck up the other side and back round the oars, or similar but crossed on top of the oars.
Hope that helps
Si
I would have them blades towards the bow of the boat, half on each side the of the boat. Lashings not 100% sure about that era, most likely lashed to the thwarts (seats) either round the oars, under the thwart, buck up the other side and back round the oars, or similar but crossed on top of the oars.
Hope that helps
Si