This class is a class/campaign that focuses on the basic assembly of a kit Out Of The Box (OOTB).
It will focus on the following aspects of kit prep and assembly
-Part Clean up
-Assembly – part fit
-Assembly – seam lines
-Assembly – glue marks, gap filling
-Assembly – Alignment
-General Presentation of an unpainted kit (paint job not finished – sub-assemblies are acceptable with paint)
The Rules and Regs
The rules/guidelines are
1. Any kit
3. Any genre
4. Any scale
5. There will be weekly readings posted in the forums and you must read them and post comments with your input on the readings
6. You must post two photos of your work representing each item mentioned above. You must photo document your progress.
You can join this campaign with the same project/kit/build as another campaign on any of the other KitMaker Network sites or a new one. If you piggy back make sure you can still photo document you build.
This campaign is about technique(s).